EM100 Load Cell Digitising Unit
The EM100 is a high-precision amplifier that features an integrated analogue- to-digital converter. It leverages a 24-bit sigma-delta signal modulation to ensure exceptional resolution with low noise. Sporting an extensive selection of weighing and calibration functions, it suits a wide range of both static and dynamic weighing applications.
The device comes in four versions tailored to different applications, each certified to the relevant OIML legal-for-trade standards. An optional adapter board is available for simplified mounting to peripherals.
The device features a CAN interface with support for the CANopen protocol as well as full-duplex RS-232 and RS-485 interfaces. A USB interface is included for convenient configuration, setup and firmware upgrade. Communication to the module is based on ASCII characters sent to a variety of serial interfaces making it easy to connect to a PC, PLC or other devices. Setup is simple, using a terminal emulation program or FDC application software (available at flintec.com).
- High accuracy
- Up to 1,200 samples per second for the DC models. (80 for the AC)
- Extensive command set
- Excitation for up to 6 load cells
- CAN Interface with CANOpen Protocol.
- Serial interface for direct connection to PC or PLC
- GPIOs (2x logical inputs & 2x logical outputs)
- 6-wire technology
- OIML ‘legal-for-trade’ certifications
- Uses Flintec FDC software (for analysis and config)
- Optional adapter board
EM100 is designed for a range of universal weighing applications where high speed, accurate weighing is required. General applications include process weighing as well as process automation and control. Configurations include AWI & NAWI weighing, check weighing and gravimetric filling.